גרור פתוח עם יריעת ברזנט

FLIEGL Tandem-Plattform-Anhänger TPS 180

Customized transport solution
Configure your Fliegl vehicle to meet your requirements. The vehicle shown is an example. Production and equipment are tailored to individual customer needs.

Chassis: Center axle trailer
Fine-grained steel welded construction
Outer frame slightly angled with "Load-Lock profile" for attaching tie-down straps. Note: To attach the straps, the side panels must be opened!
"Vario-Lash" lashing rings for use in the "Load-Lock profile", 2.5 tons each, loose
Gear-supported front legs, with a straight lower part and single-sided operation on the right
Telescopic rear support
Retractable ladder at the rear
Door latch on the side
Chocks with holder
Aluminum side impact protection
Steel underrun protection
Quarter panel fenders in front of and behind each axle
Rear impact protection
Plastic toolbox with drawer and insert, w=650 / h=520 / d=670 mm, lockable with a padlock
Coupling device for center axle trailer, according to customer requirements
Axles + Suspension
SAF disc brake axles with 430 mm disc diameter
"Axle/chassis laser-aligned" to reduce tire wear and fuel consumption
Air suspension
Braking system
2-line compressed air braking system, color-coded lines for easy maintenance
Spring-loaded parking brake
Duomatic connection at the front, with connection line to the towing vehicle
EBS, electronic braking system with EBS plug at the front, with connection cable
Caution: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
with raise and lower valve
Vehicle – driving stability system
Wheels and tires
385/65 R22.5", manufacturer's choice
Steel rims, factory silver
Electrical system
24 Volt, multi-chamber lights, yellow LED lighting on the sides
2 white position lights at the front
2 white/red side marker lights at the rear
1 x 15-pole plug at the front, with connection cable
Floor
Sieve-printed panels, approx. 30 mm thick, for high point load capacity
Platform length approx. 6,900 mm
Front bulkhead / corner posts at the front
2,580 mm high, steel corner posts in a full-volume design, release mechanism for side tarpaulin on the front bulkhead
Center posts
Sliding posts, can be moved along the entire length, with 4-fold insertion pockets and a long pocket at the bottom
Insertion slats
Rows of aluminum V-insertion slats
Rear bulkhead / corner posts at the rear
Rear corner posts, steel up to the lower edge of the roof, attachment for tarpaulin with round tube and tarpaulin tensioner
Rear portal doors, 2-wing, each with 2 internal rotating bar locks
Tarpaulin
Tarpaulin with welded horizontal and vertical straps
Tensioners made of stainless steel
Customer lettering on side tarpaulins and rear portal possible
Roof
Fixed roof with tarpaulin and bows, tarpaulin color: white
Optimal rain gutter at the rear, at the top of the end bow, above the doors
Registration country / signs
Germany
with Dekra inspection and certificate (according to §13 EG - FGV)
Load securing certificate according to EN 12642 XL
24/7 service hotline
Ledpfx Aezcqh Nsh Hsrn
prepared for license plate holder, single row
Reflective strips: white, continuously on the side tarpaulin at the bottom and at the top in the corners (if visible side panels, then the strip at the bottom, on the side panels)
Reflective strips: red, around the rear portal

*also available as a drive-through version

Customized transport solution

המודעה תורגמה אוטומטית. ייתכנו שגיאות בתרגום.