מכונת הדבקת קנטים

IMA COMBIFORM K I R75 1035 V R3

TECHNICAL DETAILS

Feed speed: max. 25 m/min
Edge thickness: max. 3 mm

Panel thickness: min. 14 mm
Panel thickness: max. 55 mm
Panel length: min. 350 mm

Number of panel sizing and milling units: 3

Panel sizing and milling unit 1
Motor power: 7.5 kW
Speed: 18,000 rpm

Panel sizing and milling unit 2
Motor power: 7.5 kW
Speed: 18,000 rpm

Panel sizing and milling unit 3
Motor power: 7.5 kW
Speed: 18,000 rpm

Number of edge-processing units: 3

End-trimming unit
Number of motors: 2
Motor power: 0.22 kW
Speed: 17,250 rpm

Fine milling unit for flush trimming and rounding
Motor power: 1.5 kW
Speed: 8,600 rpm

Buffing unit
Number of motors: 2
Motor power: 0.18 kW
Speed: 1,375 rpm

EQUIPMENT
Thin-edge processing
Thick-edge processing
EVA hot-melt adhesive system
Pressure system with rubber belts
Panel alignment system at the infeed
3 milling/roughing units with NC-controlled positioning
End-trimming unit
Fine milling unit for flush trimming and rounding with NC-controlled positioning
Buffing unit
Edge coil magazine with 2 positions
Glue pot for EVA hot-melt adhesive
Set of pressure rollers with 4 pressure rollers
NC-controlled positioning of the pressure rollers
Spraying unit
CE marking

The machine is sold and delivered in its actual and legal condition (“as seen and approved”), based on photographic documentation and technical/commercial documents of a descriptive nature. The buyer has the right to inspect the goods before collection and assumes responsibility for installing, securing and operating the machine at the destination.

External reference: 3944