מכונת הדבקת קנטים

BRANDT KDF 660 GC

TECHNICAL DETAILS

Feed rate: max. 18 m/min
Panel thickness: min. 10 mm
Panel thickness: max. 60 mm
Panel width: min. 70 mm
Edge thickness: min. 0.4 mm
Edge thickness: max. 12 mm
Number of processing units: 9

Pre-milling unit
Number of units: 1
Motor power: 2.2 kW

Edge magazine and gluing unit
Number of magazine positions: 1
Number of pressure rollers: 4

Edge processing units
Number of edge processing units: 7

End trimming unit
Number of motors: 2
Motor power per motor: 0.35 kW

Flush trimming and rounding unit
Number of motors: 2
Motor power per motor: 0.55 kW

Corner rounding unit
Number of motors: 2
Motor power per motor: 0.35 kW

Grooving unit
Number of motors: 1
Motor power: 3.5 kW

Buffing unit
Number of motors: 2
Motor power per motor: 0.18 kW

MACHINE DETAILS

Total connected load: 22 kW

EQUIPMENT
Thin-edge processing
Thick-edge processing
Solid wood edge processing
EVA hot-melt adhesive system
AIRTEK hot-air system
Top pressure beam with idler rollers
Panel support guides
Pre-milling unit with automatic, time-controlled engagement
Edge roll magazine
EVA glue pot
EVA pre-melter
Set of pressure rollers with 4 pressure rollers
NC positioning of the pressure rollers
End trimming unit
Flush trimming and rounding unit with NC positioning
WD60 corner rounding unit
Grooving unit
Edge scraping unit with NC positioning
Glue scraping unit
Buffing unit
Spraying unit
PowerControl PC20 machine programming software
CE marking

The machine is sold and delivered in its actual and legal condition (“as seen and approved”), based on photographic documentation and technical/commercial documents of a descriptive nature. The buyer is entitled to inspect the goods before collection and assumes responsibility for installing, securing and using the machine at the destination.

External reference: 7517