לחץ הידראולי

Gidropress P315

Hydraulic frame press for sheet metal stamping with a force of 630 tons, designed for cold stamping.
The vertical frame press with a welded construction consists of a table and an upper plate that are connected with screws. An electrical cabinet is installed next to the press and an oil overflow tank is located deep in the foundation, which facilitates filling the press system with oil. The pressing units are removable, which makes their assembly and repair easier. The press is controlled with a button. The size of the slider stroke is ensured by adjusting the position of the end stop.

1. Nominal pressing force, tone 630
2. Rated working pressure of fluids, KN/cm 2,200
3. Slide stroke, mm 750
4. Slider speed, mm/s
a) at idle speed 215
b) during the working stroke 10
c) during the return stroke 120
5. The greatest distance between the table and the slider, mm 1400
6. Distance between posts, mm 2200
7. Table dimensions, mm
Lrsdpfx Aspgkt Sja Uek
a) from left to right 2220
b) front to back 1800
8. Thickness of stamping plate, mm 220
9. Table height above floor level, mm 410
10. Nominal force of the hydraulic washer, tf 250
11. Hydraulic cushion stroke, mm 350
12. Ejector speed, mm/s
a) when going up 51
13. Press size, mm
a) from left to right 5070
b) front to back 3000
c) height 7065
14. Press height above floor level, mm 5480
15. Weight of the press, kg 69400
Electric motor revolutions 1450 min-1
Operating voltage 400/230 V
Mains frequency 50 Hz ± 1%
Rated air pressure 0.7 Pa