מסוע

die magnetprofis

The system was manufactured for a customer project but was not put into operation due to a subsequent change in the installation requirements. The conveyor belt is in new condition and is immediately available. This provides the opportunity to purchase the system at a significantly lower price than the new price.

Aluminum angle conveyor with substructure, including adjustable feet and machine feet for leveling uneven surfaces.
Horizontal section: 750mm
Rising section: 2,300mm
Inclination angle at the bend: 60°
Height of the horizontal section: 250mm
Conveyor belt length measured on the floor: 1,900mm
Discharge height: 2,200mm

Design:
Aluminum construction
- 2x profile reinforced 90x45mm
- Full-surface wear plate, 2.0mm, galvanized
Chsdpfx Anjzfi A As Eoc
Drive roller + deflection roller, S235 steel, welded and machined
Ø100x520mm, crowned, shaft fixed with tension bearings
Drive: Gearmotor, 0.55KW, speed 0.53m/sec
Connection 230/400V, 50Hz, protection class IP54
Drive ready for connection up to the motor terminal box
(Commissioning must be carried out by a qualified electrician)

PU conveyor belt DM 10/2 0+005 PU including wave edge PU petrol matte
Conveyor belt width: 500mm
2 pieces of wave edges, 50mm high, 25mm wide, high-frequency welded
21 pieces of T-40 studs, 300mm long, approx. 300mm spacing
Belt material: 2-layer, particularly dimensionally stable in the transverse direction

In the bend area, the belt is guided on both sides with 2 pressure rollers each.
The belt is designed with a border-free zone of 70mm on both sides.
Due to the wave edge on both sides, the usable width of the conveyor belt is reduced:
Usable width: 300mm, as follows:
(Top view) Transverse arrangement: 70+25+5+300+5+25+70mm

Belt guidance via PVC wedge strip on the running surface, profile - 10x6mm
- Including recess in the wear plate
- Including sliding joints in the drive and deflection roller

Inspection possible after consultation
Price is net, plus 19% VAT.

המודעה תורגמה אוטומטית. ייתכנו שגיאות בתרגום.