אדג'נדר

IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20

Single-Sided Narrow Edge Bander IMA NOVIMAT / CONTOUR / I / G80 / 790 / L20 with Servo Unit for Corner Copying MFA
Year of Production: 2009
Condition: Very good

Features:

* Stable machine frame with mounted processing units
* Electronically adjustable feed speed: 6–30 m/min (feed rate of processing units is not synchronized with full feed adjustment)
* Feed chain guided in sliding rails with plastic pads and 80 mm wide rubber lining
* Automatic lubrication of feed chain controlled by the machine program
* Upper pressure roller: double V-belt, 70 mm wide, on ball-bearing rollers; electronically adjustable
* CE-compliant machine safety
* Noise-reducing and protective covers
* Edge banding unit with drive enclosed in sealed oil bath and glue pot (1 main pressure roller + 5 auxiliary rollers); Quick-Lock pneumatic glue pot system for fast replacement
* Touchscreen display
* End trimming saw unit for cutting excess edge at front and rear corners, including: pneumatic saw adjustment 0–25°, straight cuts, corner chamfering, automatic saw positioning for two edge thicknesses (e.g., 0.4 and 1.2 mm), and excess edge adjustment for corner copying
* All processing units equipped with chip extraction
* Novimat Contour series maintains high processing quality due to powerful corner copying unit and minimal spacing between workpieces (\~300 mm)

Basic Technical Data:

* Roll edge thickness: 0.3–3 mm
* Paper, PVC, and ABS edges: 0.3–3.0 mm
* Veneer: 0.5–3.0 mm
* Wooden strips: 0.8–20 mm
* Edge height: 14–65 mm
* Maximum top edge overhang:
Nedpfx Ajw R S Slogbslk

* Up to 8 mm thickness: 5 mm
* Over 8 mm thickness: 2 mm

Workpiece Dimensions:

* Minimum length (feed direction): 150 mm
* Minimum width (for thickness ≤25 mm): 65 mm
* Minimum thickness: 8 mm (without flat planer) / 12 mm (with flat planer)
* Maximum thickness:

* Without corner copying: 60 mm
* With corner copying: 40 mm
* Smallest workpiece: 150 × 150 mm or 65 × 300 mm (\*65 mm width for max thickness 25 mm)

Machine Parameters:
* Electronically controlled feed: 6–30 m/min (may be limited by individual units)
* Workpiece protrusion beyond feed chain:

* 38 mm (edge thickness 0.3–8 mm)
* 30 mm (edge thickness 8.1–20 mm)

Power Supply:
* Voltage: 400/230 V, ±5/–10% with neutral
* Frequency: 50 Hz
* Control voltage: 230 V AC / 24 V
* Compressed air: 8 bar
* Extraction air speed: 28 m/s