מכונת כרסום מחרוזת מדרגות מכונת כרסום מדרגות

SCHEER mit Versand Typ TW4 mit Oberfräse HM16 TOP ZUSTAND

Stringer milling device SCHEER TW 4 + Router HM 16

Everything is in excellent, like-new optical and technical condition, the device has been used very little.
Fully functional—ready to use immediately.
All machines are intended for commercial use, no DIY store scrap.

Treppenwangenfräsgerät SCHEER TW 4

With this device, you can mill treads and risers very precisely and accurately.
The hand crank even allows you to machine curved joint surfaces; you can also use it for recesses in other panel materials, such as worktops.
Equipped with hardened guide rods, on which the cross support with router is mounted.
Featuring ball bearing guide bushings, allowing the device to move very easily, accurately, and safely.
The device can be clamped securely onto the stringer or similar workpieces using four screw clamps.
The cross support has two stops each in both the longitudinal and transverse directions.
Comes with two positioning angles.
Complete with manual, tooling, and all accessories.
Longitudinal milling travel: 750 mm; transverse milling travel has been increased from 75 mm to 320 mm, significantly expanding the machine's application range.
To increase the milling travel, a new base frame made of aluminum profiles was manufactured.
The modification work was carried out by a reputable engineering company.
Nkodpoyxr T Tsfx Agwsw
Everything works perfectly; this machine is a true one-off.

Router SCHEER HM 16

Very good condition, with only minor signs of use.
Very robust, thanks to triple-bearing router spindle.
Accurate concentricity and flawless milling results.
Precise column guidance and torsion-resistant milling table.
Constant speed, even under heavy load.
Equipped with high-performance motor (shows almost no signs of fatigue).
Long service life thanks to soft start (full-wave electronics).
Bearings are in good condition.
The machine is suitable for the toughest continuous milling operations.
Good visibility of the milling spindle; chips are blown away by a powerful fan.
220V, 1800W.
Speed: 18,000 rpm.
Fully functional.
With M16 female thread mount.

המודעה תורגמה אוטומטית. ייתכנו שגיאות בתרגום.