מגרסת עץ

mütek Systemtechnik MRZ 630

Special price for our demonstration machine
Another machine, available now (ex works in Neckartailfingen)
Approx. 8 operating hours.

Suitable for shredding all types of leftover wood and also pallet sections.

The pallet would need to be prepared with a jigsaw or chainsaw so that it fits vertically into the hopper - see Figure 2. Ideally, it would be approximately 40x20x20 cm so that the wood can lie flat on the slider floor. This is where the machine works most effectively.
Rcsdpfxjdwktkj Abyob

A hydraulic slider runs at the bottom of the shredder, which pushes the wood against the rotor depending on the load. The material is shredded until it passes through the screen basket.

Throughput up to 200 kg per hour *depending on the screen and how well the material is prepared.

*Conveyor belt and overhead magnet available at an additional cost.

+ Powerful 18.5 kW motor,
+ Concave blades,
+ Large high-performance gearbox,
+ Special, load-dependent slide control,

Customs tariff number: 84659600
Motor: 18.5 kW; 400 V - 50 Hz - 3 phase

Blades: 15, multi-rotatable
Option: double row of blades + €995 net

Rotor diameter: 260 mm
Control: Siemens S7-1200 PLC
Cutter opening: 630 x 820 mm
Filling volume: approx. 0.6 m³
Hydraulic slide gate
Screen perforation of your choice (10 - 30 mm)
Suction nozzle diameter: 160 mm
Weight: approx. 1,300 kg (depending on accessories)
Dimensions (L x W x H): approx. 1,737 x 1,167 x 1,650 mm
Moisture content: 30% dry

Included as standard:
- V-rotor for maximum throughput
- Control cabinet with Siemens PLC control
- Automatic star/delta start-up
- Fast hydraulics
- Auto. OFF when the rotor is idling
- Speed 70-90 rpm for high throughput
- Cyclic control to avoid idle times
- Performance-enhancing step control of the hydraulic slide
- Pertinax guides for the hydraulic slide
- Vibration-damping machine feet
- CE compliant.
- MADE IN GERMANY
.
Shredder options:
- Raise shredder by 30 cm (prepared for conveyor belt) +€2,080 net

- Articulated conveyor belt +€8,770 net
Horizontal section: 1,200 mm
Rising section: 2,500 mm
Angle: adjustable from 0-60 degrees
Discharge height: approx. 2,000 mm
+ - 100 mm

- Overbelt magnet +€5,980 net
- Conveyor belt and overbelt magnet control +€2,750 net
(Start and stop synchronized with the shredder)
- Extend hopper +€940 net
- Eco-rings: +€1,980 net
(recommended for more than 15% hardwood)
- Special scraper +€990 net
(recommended for veneer or paper)
- Double Knife series + €995 net
.
Raw material requirements:
- The moisture content (dry) must be below 30%
- Metals and mineral contaminants such as sand, stones, etc. lead to increased wear.

המודעה תורגמה אוטומטית. ייתכנו שגיאות בתרגום.