מרכז עיבוד עץ

Holzfraese HP 1890

Used machine

Year of manufacture: 2019

Only 110 operating hours!

Equipment and technical data:

Working travels:

- X = 1800 mm
- Y = 900 mm
- Z = 80 mm

Made from 18 mm Koskisen boards.

Milling table in 19 mm MDF as a sacrificial plate with guide rails and T-slots, serving as a clamping method.

Subframe with struts, filled with polymer concrete, prepared for transport by pallet truck or forklift.

Mechanical set consisting of profile guides including guide carriages, as well as ball screws 2010 and 1605 for all axes.

Shaft couplings and high-performance grease for lubricating the individual carriages, as well as energy chains including connection sets.

Gbjdpfx Acezk Npgjiep
Control set consisting of a Triple Beast for controlling 3 axes, with an Ethernet connection.

Leadshine end stage for the fourth motor. Four stepper motors, 5.0A, 3Nm with motor cables, as well as a switch-mode power supply with 48 V, 6.7 A, LED board for breakout board, flat ribbon cable and proximity sensors, small parts such as conductor sleeves, crimp connectors, control cable, heat shrink tubing and cable lugs. Pre-installed in an aluminum housing including electrical set and emergency stop.

- 21.5 inch monitor as a built-in monitor, including Mini PC with Windows 7, CAD software Rhino 5.0, G-code generator Estlcam, control software Beamicon2, as well as mouse and keyboard, pre-installed in an ergonomic console.

Tool length sensor for determining the length and modifying the active zero point offset.

Special equipment:

- High-frequency spindle with 2.2 kW, including lock nut, frequency inverter, mains filter, braking resistor, as well as collet set.

- PC with 8 GB RAM and AMD processor

- CAD software Rhino 5.0 for creating both simple 2D data and 3D solid models.

Availability: short notice

Location: Flörsheim
Like new

המודעה תורגמה אוטומטית. ייתכנו שגיאות בתרגום.